Highway pegs

[EZdriver]

I went to my local bike shop that stocks Kuryakyn. We tried every one in the book, but none fit. I'm 6'5" and am a little cramped on the pegs. Also, where can I find front floorboards?

[JHD]

Well at 6'5" you must feel cramped. I'm 5'9" and feel a bit cramped also. Well I installed the Premium Mini Boards with the Longhorn Offset mounts. I have large feet that I could never get comfortable resting on a traditional highway peg. The Longhorn Offset mounts should have enough adjustment especially if you have real long legs.

Hope this helps.

Brad

[SgtSlag]

For highway floorboards, I've used two sets of these, on two different bikes, including my Voyager: link. They're made of heavy aluminum, and the clamps fit the 1" OD of the engine guard bars. I do, however, recommend you wrap the bars with rubber from an old inner-tube, to prevent the clamps from marking the tubes; it will also aid in securing the clamps in place. Cheers!

[Steve do]

I have the same ones Sgtlag has, I like them, haven't had any problems with them moving around. Good luck!

[EZdriver]

I tried something a couple days ago that helped in the legroom area. The bitch seat is adjustable as well as the trunk. I moved the trunk back as far as I could, I pulled the back seat and removed the rails and adjuster. I then uses some of the industrial mushroom lock velcro to reinstall that seat as far back as it would go. This moved me back almost three inches. I don't need that seat to adjust.