Speedometer Cable
Moderators: the2knights, Highway Rider
-
Mytagg
- Newbie
- Posts: 2
- Joined: Thu Dec 23, 2021 12:25 am
- 2
- Current bike(s): 2001 Kawasaki Voyager XII (ZG1200-B15)
- Has liked: 0
- Been liked: 0
Speedometer Cable
My speedometer cable went bad and the last twi I installed broke after 6 miles. I don't know what could be wrong. Any ideas?
-
Scott-(Altoona, PA)
- King of the Road
- Posts: 1085
- Joined: Mon Feb 18, 2008 1:22 pm
- 16
- Current bike(s): 2001 Voyager XII
- Location: Altoona, PA
- Has liked: 83 times
- Been liked: 140 times
- Contact:
Re: Speedometer Cable
First (and last) speedo cable (both cable/wire and casing) I changed on my XII was purchased from Carl Leo who advised that I soak it in a small tub of old (or new) oil so it was completely filled internally. Drain the oil for a few seconds and install. This gives great protection from water damage (a.k.a. rust) that can occur with tires throwing rain onto/into the lower housing unit. The change was about 11 years ago and it's been fine (knock on wood) ever since!
My advice, get a new cable - soak it in oil prior to installation. periodically remove & reinstall the lower connection and drain any water that may have collected if riding in wet conditions.
My advice, get a new cable - soak it in oil prior to installation. periodically remove & reinstall the lower connection and drain any water that may have collected if riding in wet conditions.
- These users liked Scott-(Altoona, PA)'s post:
- Nails (Thu Feb 10, 2022 5:37 pm) • cushman eagle (Fri Feb 11, 2022 1:35 am)
- Rating: 22.22%
Mid-Atlantic Voyagers chapter secretary {"scribe"}
2001 Voyager XII
We may not know them all, but we owe them all! Thank a Veteran today!
2001 Voyager XII
We may not know them all, but we owe them all! Thank a Veteran today!