I'm a newbie to the site and the bike
Moderators: the2knights, Highway Rider
-
- Newbie
- Posts: 3
- Joined: Mon Mar 14, 2016 2:13 am
- 8
- Current bike(s): 93 kWai
- Has liked: 0
- Been liked: 0
I'm a newbie to the site and the bike
I bought my voyager March 1st it had been setting a few years but threw a battery in it and it cranked over. It's rough but complete so I paid the 500 the guy was asking. I took it to my buddy that runs a motorcycle shop and had him rebuild the carbs change the oil and filter an flush the coolant system. Went by today after work and we fired it up an ran it about 20 mind when I noticed a puddle on the floor. Tracked it down to where it was leaking and found the block is cracked on the left side. Which brings me to my question what does a new/used motorcycle cost? Is pulling the pretty straight forward ? Or is the bike worth more in pieces/parts? I'm grateful for any help you can give me
-
- King of the Road
- Posts: 1982
- Joined: Sat Jan 22, 2011 10:08 pm
- 13
- Current bike(s): '99 Kawasaki Voyager 1200
1958 Cushman Eagle restoration has been finished,and have put 3030 miles on her! - Location: Orrville,Ohio
- Has liked: 852 times
- Been liked: 290 times
Re: I'm a newbie to the site and the bike
Welcome to the site. As far as changing the engine,there are a number of members on here to help,but Carl Leo is probably the number one person to call,His contact information is on this site.Let us know what success you have.
'99 Voyager VXII,'58 Cushman Eagle
- Barry
- Grand Tourer
- Posts: 398
- Joined: Thu Feb 21, 2008 2:00 pm
- 16
- Current bike(s): 87 Voyager 12
- Has liked: 100 times
- Been liked: 69 times
Re: I'm a newbie to the site and the bike
It's not unusual to hear about vxii's with coolant leaks, especially after sitting for long periods of time. I've been following this forum for over 15 years. This is the first time I've heard of one with a cracked block. Is it possible you have a bad diagnosis? There's a water manifold behind the headers and it has 4 "0"rings that tend to leak with age. There's lots of other 0 rings and hoses that are a real pain to replace, but can be done with time & patience.
Did you talk with Carl Leo? He really is the most helpful person you will ever meet.
Did you talk with Carl Leo? He really is the most helpful person you will ever meet.
Barry
87 Voyager XII
87 Voyager XII
- Lucasind
- King of the Road
- Posts: 1790
- Joined: Mon Dec 17, 2012 5:44 pm
- 11
- Current bike(s): 2003 Voyager 1200
1988 Voyager 1200
1985 Voyager 1300
2008 Concourse 1400
1985 LTD 1100
1981 CSR 1000
1981 CSR 650
1979 KZ 650
1973 XL 350
1988 Eliminator
1975 CB 125
1965 S 65
and a bunch of parts ! - Location: Toledo, OH
- Has liked: 194 times
- Been liked: 69 times
Re: I'm a newbie to the site and the bike
I'm with Barry ! .... don't give up the ship ! MORE INFO NEEDED, cracked block ? (engine cases)
I am just wondering , do you visually SEE a big ol' crack in the cases ? or is it just leaking fluids
(coolant or engine oil) from somewhere of undetermined origin ? please give more details ...or post some pictures ,so we can be of more help .
I am just wondering , do you visually SEE a big ol' crack in the cases ? or is it just leaking fluids
(coolant or engine oil) from somewhere of undetermined origin ? please give more details ...or post some pictures ,so we can be of more help .
90% OF ANY JOB ...IS GETTING STARTED !
- ekap1200
- Master Fabricator
- Posts: 1364
- Joined: Fri Jul 04, 2008 12:54 pm
- 16
- Current bike(s): 2000 voyager end of year total. 108.634
- Location: Williamstown, New Jersey
- Has liked: 33 times
- Been liked: 134 times
Re: I'm a newbie to the site and the bike
Unless this sat in the freezing temps up north with no anti-freeze, I find it hard to believe it cracked. Had a guy thinking his head gasket was blown and ready to trash it, turned out to be an upper hose leaking and weeping out the spark plug drain hole . Do look it over closer before condemning the engine. Take the lower cowl plastic off and give a look see. 20 minuets of just sitting at idle is not good for it, they will overheat. And if someone put a plastic tie on the coolant recovery hose it will begin to leak at the fill neck where that hose is connected. Could be some bad hose somewhere . But if you find it needs an engine, just ask around here, many here have more parts for these bikes than you can imagine.
Pictures please , we love pictures
Pictures please , we love pictures
"Its not bad if you don't know something, but when you don't know you don't know; That's when your in trouble". Joe Place 1912-2008 (my grandfather)
-
- Cruiser
- Posts: 99
- Joined: Fri Aug 07, 2015 1:35 am
- 9
- Current bike(s): 2001 voyager
- Location: Long Lake, Minn.
- Has liked: 0
- Been liked: 0
Re: I'm a newbie to the site and the bike
I agree with these replys,,,,You very seldom hear of a cracked 1200 engine,,,,hopefully it is just leaking a hose or o ring,,,in the meantime welcome to the AVA,,from Minnesota
- VoyKimmer
- Grand Tourer
- Posts: 526
- Joined: Mon Mar 03, 2008 12:47 am
- 16
- Current bike(s): 2002 Voyager XII
1996 Voyager XII - Location: Gurnee, Illinois
- Has liked: 0
- Been liked: 104 times
Re: I'm a newbie to the site and the bike
Don't mistake a casting line for a crack. A leak out of a spark plug drain will look like its a cracked block at the casting line.
-
- Newbie
- Posts: 3
- Joined: Mon Mar 14, 2016 2:13 am
- 8
- Current bike(s): 93 kWai
- Has liked: 0
- Been liked: 0
Re: I'm a newbie to the site and the bike
As your sitting on the bike the crack is on the left hand side. Starts a couple inches below the jugs and a couple inches in from the corner of the motor and follows the contours of the block casting its a crack I can visually see it. I get take a couple pictures and post them on here. I appreciate any help/ advice I can get thanks a lot
-
- Newbie
- Posts: 3
- Joined: Mon Mar 14, 2016 2:13 am
- 8
- Current bike(s): 93 kWai
- Has liked: 0
- Been liked: 0
Re: I'm a newbie to the site and the bike
Well I was going to put some pictures on here but I'm not having much luck. So I uploaded some here https://tuck2056.shutterfly.com/" onclick="window.open(this.href);return false;
-
- King of the Road
- Posts: 1007
- Joined: Fri Aug 23, 2013 1:32 am
- 11
- Current bike(s): 1987 ZG-1200 B1
1987 ZG-1200 B1
1990 ZG-1200 B4 - Location: Nova Scotia Canada
- Has liked: 106 times
- Been liked: 275 times
Re: I'm a newbie to the site and the bike
Carl Leo would be the best person to talk to, but I would say you are headed for an engine swap after looking at the photos.
I'm sure Carl wouldn't mind if you were to e-mail him, voyagerparts@bellsouth.net
good luck,
Dave
I'm sure Carl wouldn't mind if you were to e-mail him, voyagerparts@bellsouth.net
good luck,
Dave
- ekap1200
- Master Fabricator
- Posts: 1364
- Joined: Fri Jul 04, 2008 12:54 pm
- 16
- Current bike(s): 2000 voyager end of year total. 108.634
- Location: Williamstown, New Jersey
- Has liked: 33 times
- Been liked: 134 times
Re: I'm a newbie to the site and the bike
Hi Tucker, I sent you a PM. Did you receive it ?tuck2056 wrote:Well I was going to put some pictures on here but I'm not having much luck. So I uploaded some here https://tuck2056.shutterfly.com/" onclick="window.open(this.href);return false;
"Its not bad if you don't know something, but when you don't know you don't know; That's when your in trouble". Joe Place 1912-2008 (my grandfather)