carb problems

Got a tech tip for Voyager 12's from your personal experiences, or one complete with pictures and instructions, here's where to post it. You can also ask about tips or procedures here.

Moderators: the2knights, Highway Rider

Post Reply
PKarl
Cruiser
Cruiser
Posts: 32
Joined: Tue Apr 14, 2009 2:19 am
15
Location: Flinton Pa..Near altoona pa
Has liked: 0
Been liked: 2 times

carb problems

Post by PKarl »

so our last ride was october last year bike ran great .parked in garage went to move it for storage in december ran like crap figured bad gas didnt have time to mess with it then so it sat so now april i start on it..drained all gas out put new gas in with seafom changed fuel filter run it let sit ran more let it sit runs horrible not idling unless turn idle in or keep choke on so i pull my vaccum gauges out and sync the carbs. so by this time i have played with different settings on pilot jet synced carbs and they sync perfect..two questions now the center screw that syncs the right to the left is bottomed out cant turn it any more but the carbs are all pulling same amount of vaccum does that matter ? second question it runs smoothly when hot runs like crap and starts hard when cold im pulling about 6 lbs vaccum at idle on all carbs like i said when hot its great when cold have to turn idle screw way in then as it warms up turn it back out..what am i missing here?
User avatar
GrandpaDenny
King of the Road
King of the Road
Posts: 1079
Joined: Fri Nov 01, 2019 4:24 pm
5
Current bike(s): 1993 Kawasaki Vulcan 1500
Has liked: 481 times
Been liked: 436 times

Re: carb problems

Post by GrandpaDenny »

when you drained the fuel, did you drain the carb bowls?
Dennis Fariello
Philadelphia, PA
2000 Voyager XII "Gertrude" - deceased
1993 Vulcan 88 "Emily"

South Jersey Retreads
Patriot Guard Riders
Warriors Watch Riders

VXII Manuals:
https://amervoyassoc.org/zg1200manuals.php
PKarl
Cruiser
Cruiser
Posts: 32
Joined: Tue Apr 14, 2009 2:19 am
15
Location: Flinton Pa..Near altoona pa
Has liked: 0
Been liked: 2 times

Re: carb problems

Post by PKarl »

Well yes and no i drained the fuel bowels several times before i drained the fuel then drained fuel put new in the fuel looked fine have a clear see thru filter on it and its looks very clean
User avatar
ekap1200
Master Fabricator
Master Fabricator
Posts: 1364
Joined: Fri Jul 04, 2008 12:54 pm
16
Current bike(s): 2000 voyager end of year total. 108.634
Location: Williamstown, New Jersey
Has liked: 33 times
Been liked: 134 times

Re: carb problems

Post by ekap1200 »

By chance , did you inspect the air box for rodents ? . How did it first start up after sitting for a long time. Perhaps you may have a fouled spark plug. What brand , if any , fuel conditioner was in the tank ?
Gene.
These users liked ekap1200's post:
cushman eagle (Fri Apr 16, 2021 10:07 pm)
Rating: 11.11%
"Its not bad if you don't know something, but when you don't know you don't know; That's when your in trouble". Joe Place 1912-2008 (my grandfather)
PKarl
Cruiser
Cruiser
Posts: 32
Joined: Tue Apr 14, 2009 2:19 am
15
Location: Flinton Pa..Near altoona pa
Has liked: 0
Been liked: 2 times

Re: carb problems

Post by PKarl »

nothing in air box but filter i had been adding i capfull of 2 stroke oil everytime i gassed up doesnt sound like its missing but do plan to check plugs..when i changed plugs i added 1 can of seafom to 4 gals of gas put about half of it in its about all gone now
User avatar
ekap1200
Master Fabricator
Master Fabricator
Posts: 1364
Joined: Fri Jul 04, 2008 12:54 pm
16
Current bike(s): 2000 voyager end of year total. 108.634
Location: Williamstown, New Jersey
Has liked: 33 times
Been liked: 134 times

Re: carb problems

Post by ekap1200 »

Well I wouldn't recommend adding 2cycle oil its really not needed. As for a full can to 4 gal, of seafoam , well I have always just followed their recommended dose of 1 oz per gal. Messing with the fuel screws made no change ? Did you put them back to where you found them ? What is the condition of the plug - caps ? And while at the caps you may want to check the plugs. Are you sure the choke is working ? Are you using a professional set of gauge's to sync the carb's ? It's always good to check the gauges accuracy to each other from time to time .
Have you had the bike out on the road ? Sometimes a good ride may clear out whats ailing it. My grandfather used to tell me, IT CANT BREAK OR GO OUT OF ADJUSTMENT JUST SITTING.. if it ran well before you shut it down then changing adjustments may just add to your problems.
Gene Kap.
"Its not bad if you don't know something, but when you don't know you don't know; That's when your in trouble". Joe Place 1912-2008 (my grandfather)
buzzcut
Cruiser
Cruiser
Posts: 45
Joined: Sun Jul 12, 2020 4:07 pm
4
Current bike(s): 2001 zg1200, 1986 zg1000, 1983 gs1100, 1981 cm400a
Has liked: 1 time
Been liked: 39 times

Re: carb problems

Post by buzzcut »

Just had a think...different bike but it had run really well in the fall, total crap in spring. Even shop could not do anything with it. Discovered the airbox had cracked and letting in way too much air. Just a thought....
User avatar
GrandpaDenny
King of the Road
King of the Road
Posts: 1079
Joined: Fri Nov 01, 2019 4:24 pm
5
Current bike(s): 1993 Kawasaki Vulcan 1500
Has liked: 481 times
Been liked: 436 times

Re: carb problems

Post by GrandpaDenny »

Too much seafoam will cause running like crap. Use the recommended amount. Even in worse-case scenarios, like when you're dealing with kronked-up carbs and trying to get by on the cheap, a half-can per full tank is the MAX to use. Even that is probably too much.
Dennis Fariello
Philadelphia, PA
2000 Voyager XII "Gertrude" - deceased
1993 Vulcan 88 "Emily"

South Jersey Retreads
Patriot Guard Riders
Warriors Watch Riders

VXII Manuals:
https://amervoyassoc.org/zg1200manuals.php
User avatar
JimK
Cruiser
Cruiser
Posts: 44
Joined: Mon Feb 28, 2011 5:25 pm
13
Current bike(s): 1997 Kawasaki Voyager XII
1990 Harley Ultra Classic
Location: Kingman, AZ
Has liked: 5 times
Been liked: 5 times

Re: carb problems

Post by JimK »

You state it runs great when hot. So I believe because it’s hard starting and runs bad when cold your problem is in the enricher (choke) circuit. The enricher circuit adds fuel when cold. There are plungers on the carbs that rich out the mixture when the choke lever is engaged. If one or more are plugged or not working properly the mixture when cold will be way off and the bike will run poorly. As it warms your not using the choke circuit anymore the engine runs as it should. The enricher circuit works different than an old style choke. The choke would restrict the air passing through the carb, an enricher adds more fuel. I think Kawasaki calls the enrichers, starter plungers.
User avatar
SgtSlag
King of the Road
King of the Road
Posts: 1057
Joined: Mon Oct 04, 2010 10:04 pm
14
Current bike(s): 1993 Voyager XII (2010)
(2006-2012: 1979 Honda CB750K)
(2008-2010: 1983 Kawasaki 440LTD, belt drive)
Location: Minnesota
Has liked: 23 times
Been liked: 238 times

Re: carb problems

Post by SgtSlag »

SeaFoam specifies 1 oz. per gallon, for fuel addition purposes. A can holds 16 oz., so 1/2 can is only 8 oz. OP used 8 oz. of SeaFoam in 6.5 gallons of gas -- not terribly excessive: 1.23 oz./gallon, instead of 1.0 oz./gallon. I've run higher, as a one-time flush-out. It ran a little rough. I agree, the scripted 1.0 oz/gallon of gasoline is preferable. Occasional use (1 dose/month during riding season), as a preventative measure, is also highly recommended. Marvel Mystery Oil (MMO) does almost everything that SeaFoam will do, and it costs roughly 1/4 the price of SeaFoam, per oz.; I only use SeaFoam as a fuel preservative for off-season storage now, since MMO is so much less expensive. Cheers!
SgtSlag

1993 Voyager XII
PKarl
Cruiser
Cruiser
Posts: 32
Joined: Tue Apr 14, 2009 2:19 am
15
Location: Flinton Pa..Near altoona pa
Has liked: 0
Been liked: 2 times

Re: carb problems

Post by PKarl »

Well it starts fine really i choke it whole way it cranks maybe 10 seconds runs a few seconds shuts off the crank again it starts and stays running with choke on then as warms up can start backing choke off if i back it off to soon it will idle very low and sometimes shut off till i turn idle up then when its hot the idle is way high like 2000 rpm high and have to turn it back down..i havent got back to it yet maybe later this week i will plan tp pull plugs put new sparkplug caps on new fuel and filter and see where im at
Post Reply

Return to “Tech Tips - Voyager XII (1200 Four)”