Got a tech tip for Voyager 1300's from your personal experiences, or one complete with pictures and instructions, here's where to post it. You can also ask about tips or procedures here.
I'm getting ready for re assembly of my engine but I'm unsure of this one step. #6 on page 101
6. Outer race of driveshaft needle must be fit with a...
Last post
Sorry I'm not too familiar with the specifics of your Voyager 1300 engine. For that step about fitting the outer race of the driveshaft needle with a...
Hey - great forum!
1984 Voyager 1300 approx 60k miles
I am trying to split my cases . I have all of the bolts removed, followed the procedure in the...
Last post
Hey just in case anyone was wondering on my 84 zn1300 the rotor definitely DOES need to come off in order to split the cases. That surprised me...
Howdy again, This will be part 2 for those who read my first post. If you have never removed the 1300 rear wheel before, I think it's easier than a a...
Last post
THIS IS GOOD STUFF... 'MIGHT HAVE TO TACKLE IT ALL MYSELF and appreciate the saving of time!!!
Is there a good fuel injector cleaner out that under $100 that will allow me to connect the fuel injectors and pump cleaning fluid through them while...
Last post
Does anyone know where I can find replacement fuel injectors?
I figured out the fuel hose routing.thanks to this forum. I was directed to the fuel pump relay thanks to this forum.i didnt need to mess with that....
Last post
Black and yellow is ground. One of them is to DFI negative
First i nearly didnt know where lines to fuel filter connected and then it to injectors.got that all connected.fuel lines from fuel tap were brittle...
84 voyager 1300. Has sat indoor storage 4 years. Tank was empty. I put 2 gallons in it. I put a brand new battery.all lights work, horn doesnt. Motor...
Last post
Heres some info i should add.first i really appreciate your help. This bike is very clean even though it sat inside 4 years.a guy had a $35.00 repair...
84 Voyager 24k. Last year the light came on the dash. Level ok. Cleaned the sensor and still on. Had read somewhere how to run a jumper wire to turn...
I notice the KZ1300 manual details a procedure for changing the rear shock fluid - basically: unscrew the air hose, dump the fluid out, completely...
Last post
I always drain the shock fluid into a marked container (cc). And only refill with the amount drained. My strong recommendation is to only use any ATF...
Fuel pump is bad. New pumps are no longer available. Found 3 used on E-Bay priced from $224-$300, anywhere from no warranty up to 30 days..... that's...
Last post
Somebody emailed me this a number of years ago from the Yahoo Voyagers Group. I hope it helps.
The last time this was discussed here, I took the...
just picked up an 84 Voyager. Hasn't run in approx. 2 yrs. Removed tank due to rust, prepping for treatment and discover the petcock is completely...
Last post
Here are some measurements I made of my tap. The critical measurement is the bolt hole spacing which I show as 43.5mm - not sure how accurate that is...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
