head gasket

Post by **phill12** » Thu Mar 20, 2008 12:58 am

Last week i bought a 1993 Voyager to go along with my 1988. After getting it all set up and ready to go, I notice a small antifrezee leak on the back side of the head #2 cyl. position. Has anyone ever pulled the head off with the engine in the frame? If so is there any tricks I need to know about?

Phill Griggs
past member and new member AVA

<This post moved from Forum Use Questions- Board Admin>

Post by **carl leo** » Mon Mar 24, 2008 12:21 am

sir, there are two water pipes going from the water manifold to the head, the o rings on the pipe is bad. not hard to repair but get the correct o ring, do not try to match one up from a hardware store.