Got a tech tip for Voyager 12's from your personal experiences, or one complete with pictures and instructions, here's where to post it. You can also ask about tips or procedures here.
I took an unused mirror out of the attice and put it to good use. Set it up behind the bike's parking spot in the garage as an easy way to check all...
Last post
I'll have to look around. I also see that you have the center brakelight active. That is a nice plus that has cost some folks close to $100 to buy...
I have had the notorious head shake since I bought my '93 2 years ago. It started showing up mainly on decel at about 35-40, just like others have...
Last post
I used a couple of bungee cords and a towel and used the windshield to hold the handlebars up. I wonder how much that head tool costs? I've tightened...
Come on. Your holding out on the best idea I've seen on your bike. Show us some pics of that nice storage idea you've invented for all the maps and...
Last post
Wayne - awww, you're making me blush. Shoot, that's just one of those 'portfolios' from the school/office aisle counter at Walmart - held to the top...
I got tired of what was out there for glove rain covers - so I came up with this, hope you enjoy it, and add your own touches. :-D
Supplies needed –...
I think I figured out what's wrong with the AM radio on my Voyager. I took the whip antenna off the back, unscrewed the little, chrome nut that holds...
I'd been meaning to post this for some time as I've found it so interesting - and easy to do. This morning (forgive me board oversee-ers), it's also...
Last post
I found just the opposite. I have almost 21K on my front tire, while my rar with @ 9.5k is almost ready to replace.
After upgrading to an AGM battery from Wesco, my Voyager battery sensor light was no longer needed - but I didn’t want to waste the possible use of a...
Last post
John, from what a electrical techie tells me, you're right about the resistor as you could just install in 'in line'. The only concern he had was to...
Last week i bought a 1993 Voyager to go along with my 1988. After getting it all set up and ready to go, I notice a small antifrezee leak on the back...
Last post
sir, there are two water pipes going from the water manifold to the head, the o rings on the pipe is bad. not hard to repair but get the correct o...
If you are talking about the propeller shaft sliding joint, yes, that should be packed with about 16 grams (20ml) of high temperature grease. This is...
Last post
Thanks for the reply, Gary. Actually I am inquiring about the other end of the shaft, the one nearest to the engine. The service manual doesn't...
'Getting ready to take my first big solo ride - to ride the LSV HCT, I'm really going over my bike to prep it. Including new plugs.
.
Following a tip...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
