Got a tech tip for Voyager 12's from your personal experiences, or one complete with pictures and instructions, here's where to post it. You can also ask about tips or procedures here.
As the title indicates, I am in need of a new crossover hose. Mine is leaking. I know the standard recommendation is to replace the shocks but I'd...
Last post
I’m not a saver of old stuff like my lady friend who is kind of a hoarder. I quite often bag up old shoes, cloths and other stuff that has been in my...
Where is the best places to get a starter from for a 87 everything I find is over 125.00 need the whole thing the one I had inside magnet was broke...
Last post
Thinks for the advice I want ahead and order the replacement hopefully gets here tomorrow and I hope I do not have a starter Clutch issue Because at...
So I believe the consensus is to use Dunlop Elite 4 tires, yes? no?
The service manual states my tire size for the front is 130/90 - 16 67H, and the...
Last post
Thanks Barry! I am usually pretty good at figuring stuff out but it was stumping me how quickly you got info to me the first time and I went and was...
I'm sorry to say that's what mine sounded like when the starter chain broke. Engine needs to come out & be completely torn down. It would be cheaper...
I know that the answer is in this website somewhere but, I must not be looking in the right place...
On the front forks, I have looked at the tech...
Last post
When I changed my front fork oil I did it as shown on the link in this thread. Hardest part was getting the retaining clip out. I measured the amount...
As some of you have read for my previous post as of right now this is where I stand pulled starter out. It works believe i just had bad ground? Had...
Last post
Get a hold of Carl Leo down in Florida. He's replaced hundreds (literally) of starter chains on 86-87's. He's a great source for information and will...
I'm a new bike rider/owner
The issue I have is no start when pressing start.
If I push the bike and dump the clutch in first as I push the start...
Last post
The starter is only 2 hex head bolts, and the positive cable disconnected, to remove and then it can be bench tested. Hook up a good battery positive...
I just picked up my 2nd Voyager that only had 9800 miles. The only problem is it has to warm up a very long time with the choke on to be able to...
Last post
Yep: three years of varnish build-up is beyond what SeaFoam/Marvel Mystery Oil (MMO) can handle, typically. In your situation, most of the jets were...
Questions for the knowledgeable and experienced Voyager XII hive mind...
Shopping for replacement parts (driveshaft and final drive) for my 91, and...
Last post
While waiting for the U-joint, clips & O-rings to arrive, I removed the coupling that is at the other end of the driveshaft. That was another pain as...
Hi I have a 1994 voyager, was riding yesterday and all sudden when I took off from light it felt lik I was in second gear lugin outta hole, then when...
My 94 voyagers mirrors got loose as they do and everytime I hit a bad bump they would move. Very distracting and we know that's not good. I saw the...
Last post
Was Just putting it out there ,I realize this is kinda a Mickey mouse fix with the sand Vaseline mix. But it is working very good so far and I put a...
Hey guys, how far up does the solid part of the bars go? Is it solid like round stock, or is it an insert that can be removed (or drilled out)? I...
Last post
To the best of my knowledge this is the only bike with this type of handlebar adjustment. I also heard that the reason for different diameters was to...
I have a 1993 Voyager 1200. There is an electrical drain that is getting worse. I rode it for a half hour today starting with a full charge and when...
Last post
Update on the drain issue. The alternator was bad. Just took it out for a short run and the battery is holding nicely. Putting out close to 14 volts...
Hello everyone. I recently purchased a very clean 1995 and have been in the process of getting it completely lined out. So far I've added new tires,...
Last post
My bike has 36,000 miles. I was able to pull the drain bolt and spray carb cleaner up through the overflow nipple, flushing it out of the drain bolt...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
